pk10预测规律

Banner
Home > News > Content
Yuanyi spreader teaches you how to maintain the spreader
-2019-12-07-

Yuanyi spreader teaches you how to maintain the spreader:

First, the machine casing: use a clean cloth or air gun to remove surface dust, the cycle is every day.

Second, origin induction: Use a clean rag or air gun to remove surface dust, and stop the machine at the origin, and see if the origin induction indication is good, the cycle is every day.

Third, the opposite side of the electric eye, the opposite side of the start, the presence or absence of cloth, unbundled photoelectricity, tightness detection photoelectricity: use a clean rag or air gun to remove surface dust, and check whether the photoelectric switch induction is good, the cycle is daily.

Fourth, the flattening device: cut the thread around the pulley to remove dust, the cycle is every day.

V. Power cable: remove the dust and other debris on the steel wire rope, the cycle is every day.

6. Lifting mechanism: Use an air gun to blow away dust from the sprocket and guide groove, and check whether the lifting and lowering limit is good. The cycle is every week.

7. Walking wheel: remove foreign objects on and around the walking wheel. The cycle is weekly.

Eight, guide wheel: check whether the guide wheel and the stainless steel edge are tight, tighten the screws, the cycle is every two months.

Nine, opposite motor: remove the dust on the chassis, remove the foreign objects on the opposite rack, and add lubricant, the cycle is every three months.

X. Drive the chain: remove the foreign matter on the chain, adjust the tightness of the chain, and add lubricating oil, the cycle is every three months.

Eleven, round knife: When the round knife is not sharp, the sharpening operation can be performed. When the front edge of the round knife is finished, the round knife should be replaced. The cycle is every year.

Twelve, feed the speed-reduction timing belt: remove the foreign matter on the timing belt, check the wear and tear, adjust the tightness of the timing belt, the cycle is every six months.

The above is the maintenance instructions of the spreader. If the maintenance is not easy to cause problems, the use time will be longer!